TERMS & CONDITIONS
BY PLACING A BID, BIDDER CERTIFIES THAT THEY HAVE READ AND WILL ABIDE BY ALL TERMS AND CONDITIONS AS STATED BELOW. IT IS THE BUYER'S RESPONSIBILITY TO UNDERSTAND ALL THE TERMS AND CONDITIONS PRIOR TO BIDDING.

All items are sold "AS IS, WHERE IS" with no warranty or guarantees, expressed or implied, by the seller or Hallberg Auction. Bidders accept all auction items/property "WITH ALL FAULTS", whether or not immediately apparent. It is strongly recommended that bidders thoroughly inspect items before placing a bid. Items are described as accurately as possible, but do not represent any guarantee by the seller or Hallberg Auction. By placing a bid, bidder signifies that they have inspected the item to their satisfaction.
By placing a bid, the bidder is entering into a contractual agreement to purchase the item(s) from the seller. Failure to follow through with payment and pickup of items could result in legal collection proceedings.
Pictures and Item Descriptions
Multiple photos will be included in item descriptions whenever possible; however, photos may or may not fully represent the item. Lighting, surroundings and other factors can affect the perception of an item in a photo; therefore, all bidders are responsible for their own personal inspection of the item(s) before placing a bid. Photos and descriptions are to be used as a guideline only.

Odometer, Mileage & Hour Meter readings are assumed to be correct. These assumptions do not constitute a guarantee. It is up to the bidder to validate the accuracy of the reading during the inspection process. Hallberg Auction is not liable for any inaccuracies pertaining to odometer, mileage and hour meter readings.
Auction Software
Hallberg Auction will not be held liable for any software or software malfunction discrepancies.
Invoicing
An invoice and payment instructions will be sent to each buyers registered email at the close of the auction. Please read email message completely for payment instructions. Please contact us at (800) 373-2255 if you do not receive an invoice from us within 24 hours of auction close.
Payment
Successful bidders must contact Hallberg Auction within 24 hours after receiving their invoice to confirm their method of payment.

Payment must be received within 7 days after the conclusion of the auction.

If payment is not received or payment arrangements made within 7 days after the conclusion of the auction, the buyer will lose all right, title and interest to the item(s), including any and all moneys.

Auction items will not be released for pickup until payment is made in full. Failure to comply with these terms will prohibit bidder from participating in future live or on-line auctions conducted by Hallberg Auction.
Item Pickup
Removal and/or transportation of item(s) won on auction shall be at the expense, liability and risk of the buyer. Any Items not removed within 3 weeks of the conclusion of the auction, unless arrangements have been made and agreed upon by seller, will be considered abandoned and the purchaser will lose all right, title and interest to the property, including any and all moneys from the buyer.
Returned Check Fees
A fee of $35.00 will be assessed on returned checks and may result in the bidder being denied access to future auctions. Be sure you are capable of paying immediately after the conclusion of the auction and realize your bids are not conditional upon financing.
Payment Procedures
Payments will be made to Hallberg Auction.
Forms of payment: Company/Personal Check, Cash, or Credit Card (with a 3.5% convenience fee for use of a credit card).
All Checks are to be made payable to Hallberg Auction
Mail checks to:
2409 Hwy 9
Buffalo Center, IA 50424
*Please include your bidder number in the memo line
If paying by credit card, please call our office at 800-373-2255 with your credit card information.
We accept Master Card, Visa, American Express and Discover.
There is a 3.5% convenience fee per transaction for all credit card purchases.
Titles
Titles will be sent via standard mail 7 days after payment has been received, unless otherwise specified in the description of the item, and will be mailed to the address provided by bidder upon registration.
Reserve Bidding
Items on auction may have an undisclosed reserve. Sellers, Hallberg Auction, or other agent of seller may bid on items up to reserve amount in order to aid in the sale of the item.
*By placing a bid, bidder signifies that they have inspected items to their satisfaction.
*Hallberg Auction reserves the right to remove any property prior to close of the auction.
*Hallberg Auction reserves the right to reject any bid at our discretion.
*Bidders who register at any of our auctions will be included in our mailing lists to receive print or digital communication regarding upcoming auctions. Your information will not be sold to third parties and you may opt out of receiving notices at any time.
Item Descriptions are for Identification purposes; they constitute no warranties expressed or implied. You are encouraged to make your own in-person inspection of all property before bidding.

Two Day Sapp Machinery Auction Wednesday, September 9th (Online Only) and Thursday, September 10th (Live and Online) 2409 Highway 9, Buffalo Center, Iowa Wednesday September 9th Online Only Auction for Small Line items Lots begin closing at 5:00 pm Items to include: tools, shop items, woodworking equipment, light trailers, lawn mowers, building materials, and miscellaneous. Thursday September 10th at 10:00 a.m. Live auction with online simulcast bidding Tractors, and Skidloader:'14 John Deere 8360R (4122 hours, ILS, IVT, Front and Rear Weights, Duals), '08 John Deere 5303 with 512 loader (524 hours, SHARP!), Agco GT45A with FL 200 loader (880 hours, MFWD), John Deere 7810 with 725 loader (5438 hours, 2WD),'99 Case IH MX 240 (MFWD, 3657 hours, Three Remotes, Trimble), Ford 946 Versatile (6186 hours, Three Point, Good Rubber), John Deere 4450 with 158 loader (PS, Good Rubber, 6675 hours), '81 John Deere 4440 (8860 hours, PS, Duals, Out of Estate), John Deere 4440 (5969 hours, QR, Front Weights, Retirement), John Deere 4430 (9063 hours, QR, Duals, Out of Estate), International 1066 w/ Westendorf Loader (reads 6625 hours), John Deere 4020 (8292 hours, Syncro, WF, Overhauled, Two Remotes), John Deere 3010 (Gas, Syncro, Runs Good), Steiger Panther ST325 (7176 hours, duals), Case 4890, Allis Chalmers 200 (5003 hours, diesel), Allis Chalmers 190 XT (Diesel, 5000 hours, bad head gasket), International 175 Crawler Loader, International 350 Utility with Loader, Farmall H with Belly Mower, Allis Chalmers WC, Minneapolis Moline U, Oliver 88, Bobcat 743 (new bucket, overhauled). Tillage and Planting Equipment: DMI 730B Ripper (7 shank), John Deere 910 V Ripper (with cart), John Deere 2700 Disk Ripper (5 shank), Case Four Bottom Plow, IH 710 Plow (6 bottom, on land), IH 710 Plow (4 bottom), John Deere F145H Plow (4 bottom), DMI Chisel Plow (11 Shank), John Deere 610 Chisel Plow, Sulky Plows, Allis Chalmers Two Bottom Plow (Snap Coupler), IH 55 Chisel Plow (27'), John Deere 1600 Chisel Plow, John Deere 100 Chisel Plow, Bush Hog Chisel Plow (12'), Lundell 1700 Disk Chisel, Glencoe SS 7400 Disk Chisel, DMI Disk Chisel, John Deere 330 Disk, IH 490 Disk (32'), IH 490 Disk (20'), IH 480 Disk, DMI 4100 Anhydrous Bar, John Deere 960 Field Cultivator (35'), IH 4700 Field Cultivator, John Deere 290 Planter, John Deere 7000 Planter (16 row), Concord 1100 Air Cart, 60' Spray Boom (3 point), Combines, Heads, Wagons, and Grain Handling: '97 John Deere 9500 (3555 Engine Hours, Well Maintained), Case IH 1680 Combine (4561 hours), John Deere 7700 Combine, '11 John Deere 608C Stalkmaster Chopping Head, '09 John Deere 635 Platform, IH 1083 Head, IH 1063 Head, Case IH 1063 (Rebuilt, New Units, Poly), John Deere 643 Corn Head, Drago Head (8 row), '03 Geringhoff Rota-Disc Head (8 row), Case IH 30' Platform, John Deere 925 Platform, Brent 544 Wagon, Crysteel 650 bu Trailer Wagon, Two Demco 350 Wagons, Parker 4000 Double Door Wagon, Two Dakon Gravity Wagons, Two Parker 2600 Wagons, Two J and M Wagons,Two Parker 275 bu Wagons, Parker Gravity Box (JD 1065 gear),Three DMI 330 bu Wagons (Center Dump), Killbros Gravity Box, Walsh Flare Box (JD Gear), Hi-Cap Model 40 Grain Cleaner, New Idea 324 Picker (wide row), Brent 874 Grain Cart, Brent 462 Auger Wagon, Peck 10-61 Auger (Swing Hopper), Westfield WR 100-41 Auger, Westfield 8-61 Auger, 8" Sudenga Auger, 14' and 16' Augers, 500 bu PTO Batch Dryer, Feterl Drive Over Hopper, more… Choppers, Hay, and Livestock Equipment: '10 MC 2408 Stalk Chopper (like new), John Deere 115 Stalk Chopper (nice), Rhino RC 20 Stalk Chopper, Hiniker 1700 Stalk Chopper (8 Row), Balzer 8 Row Stalk Chopper, MC Six Row Stalk Chopper,John Deere 120 Stalk Chopper, Loftness Chopper (6 row), Alloway 8 row Stalk Chopper, New Holland 499 Haybine, New Holland 78 Baler (with kicker), New Holland 68 baler, John Deere 535 Round Baler, New Hayrack on Gear, 16 Hayrack (metal bed), New Hay Rack Tops, John Deere Silage Wagon, Farmhand Silage Wagon (14', Kewanee Gear), H and S Silage Wagon (Westendorf WW 2416 Gear), Harsh 300 T Feed Wagon, Two TeSlaa Bale Feeder Trailers, Wooden Feed Bunks, Trails End Cattle Working Facility (never used), New Six Ton Bulk Bin, Semis, Large Trailers, Small Trailers: '13 587 Peterbuilt (Cummins, 13 spd, 1,033,209 miles), '12 Kenworth T700 (455 Paccar Motor, 765,394 miles, 10 spd, 100,000 on new motor), '05 Peterbuilt 587 (500 HP Cummins, 858,857 miles, 13 spd), '00 Mack CH 613 (400 HP, 10 spd, E-7), '97 Peterbuilt 379 Extended Hood (12.7 Detroit Series 60, 500 HP, Reman 13 spd), 48' Van Trailer (Storage Only), '92 Ford L8000 Dump Truck (Cummins, loses water), '88 Ford L9000 (198,369 miles, Cummins, Eaton 9 Speed), '79 Chevrolet Fire Truck (5,600 miles, 427 gas), '76 Ford F 700 (Omaha Standard Box), '72 Chevrolet C60 Grain Truck (366, Alllison, Twin Screw, 18' Aluminum Box), '11 Jet RGN (53' Triple Axle, Hydraulic Detach), '96 Jet Step Deck (53', Beavertail and Ramps), '98 Timpte Grain Trailer (42'x78"x96", Air Ride, 2 Speed Standard Hoppers, Aluminum Wheels and Sub Frame), '98 Midland Triple Axle Rock Trailer,'97 Wilson Grain Trailer (72" Sides), '96 Wilson Convertible Floor Trailer (102x46, newer tires and brakes), '06 Keifer Built 22' Bumper Pull (8 bolt, two ramps, nice), BCT Deck Over Bumper Hitch Trailer, DM Head Cart, Homemade Head Carts, 16' Livestock Trailer, 16' Car Hauler, 16' Tandem Axle Trailer. H and H Utility Trailer, Donahue Trailer, Other: New 10x12 Sheds, 5 yd pull behind scraper, Gnuse Bucket, Farm King 740 Snow Blower (never used), Mel Can Rock Picker, Vermeer Three Point Backhoe, Vermeer Model 12 Tiler, John Deere Snowblower for Lawn Tractor (46"), John Deere 261 Grooming Mower, Winco 35,000 watt PTO Generator, Katolight 28 KW PTO Generator, Fimco Three Point Sprayer, John Deere Pallet Forks, Allied Loader (Oliver Mounts), Hiniker 8100 Console (flow control, meter shut-off), Mousehole Anvil, Mink Cages, To consign call Hallberg Auction 800-373-2255 Taking Drop Offs August 23rd through September 8th. Loader Available Monday-Saturday 9:00-5:00 p.m. excluding Labor Day.